lkml.org 
[lkml]   [2015]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] clk: Show clock rate and error value when fail to set clock rate
Hi Sylwester,

On 04/21/2015 05:37 PM, Sylwester Nawrocki wrote:
> Hi Chanwoo,
>
> On 20/04/15 13:08, Chanwoo Choi wrote:
>> This patch shows the current clock rate nad error value when clk_set_rate()
>> fail to set the clock rate because log messgae means only the clock rate.
>>
>> Cc: Mike Turquette <mturquette@linaro.org>
>> Cc: Stephen Boyd <sboyd@codeaurora.org>
>> Cc: Sylwester Nawrocki <s.nawrocki@samsung.com>
>> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
>> ---
>> Changes from v1:
>> - Add error value of clk-set_rate() with current clock rate
>>
>> drivers/clk/clk-conf.c | 5 +++--
>> 1 file changed, 3 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/clk/clk-conf.c b/drivers/clk/clk-conf.c
>> index aad4796..2b6375f 100644
>> --- a/drivers/clk/clk-conf.c
>> +++ b/drivers/clk/clk-conf.c
>> @@ -107,8 +107,9 @@ static int __set_clk_rates(struct device_node *node, bool clk_supplier)
>>
>> rc = clk_set_rate(clk, rate);
>> if (rc < 0)
>> - pr_err("clk: couldn't set %s clock rate: %d\n",
>> - __clk_get_name(clk), rc);
>> + pr_err("clk: couldn't set %s rate to %ld (%d)\n",
>> + __clk_get_name(clk), clk_get_rate(clk),
>> + rc);
>
> Apologies for my previous misleading comment, with this patch
> you log current clock rate as the rate which was attempted to
> be set. And these two will likely be different when clk_set_rate()
> failed. So it should rather be:
>
> pr_err("clk: couldn't set %s clk rate to %ld (%d)\n",
> __clk_get_name(clk), rate, rc);

I'll modify it as following without error value.
If I add the error value, the number of character are over 80.
pr_err("clk: couldn't set %s clk rate to %ld\n",
__clk_get_name(clk), rate);

Thanks,
Chanwoo Choi


\
 
 \ /
  Last update: 2015-04-27 11:21    [W:0.042 / U:0.420 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site