lkml.org 
[lkml]   [2015]   [Mar]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 2/3] leds: ktd2692: add device tree bindings for ktd2692
Hi Varka,

Thanks for the review

On 2015년 03월 25일 12:31, Varka Bhadram wrote:
> On 03/25/2015 07:00 AM, Ingi Kim wrote:
>> This patch adds the device tree bindings for ktd2692 flash LEDs.
>> Add optional properties 'flash-timeout-us' to control flash timeout
>> and 'vin-supply' for flash-led regulator
>>
>> Signed-off-by: Ingi Kim <ingi2.kim@samsung.com>
>> ---
>> .../devicetree/bindings/leds/leds-ktd2692.txt | 33 ++++++++++++++++++++++
>> 1 file changed, 33 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>>
>> diff --git a/Documentation/devicetree/bindings/leds/leds-ktd2692.txt b/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>> new file mode 100644
>> index 0000000..f78512f
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>> @@ -0,0 +1,33 @@
>> +* Kinetic Technologies - KTD2692 Flash LED Driver
>> +
>> +KTD2692 is the ideal power solution for high-power flash LEDs.
>> +It uses ExpressWire single-wire programming for maximum flexibility.
>> +
>> +The ExpressWire interface through CTRL pin can control LED on/off and
>> +enable/disable the IC, Movie(max 1/3 of Flash current) / Flash mode current,
>> +Flash timeout, LVP(low voltage protection).
>> +
>> +Also, When the AUX pin is pulled high while CTRL pin is high,
>> +LED current will be ramped up to the flash-mode current level.
>> +
>> +Required properties:
>> + - compatible: "kinetic,ktd2692"
>> + - ctrl-gpio, aux-gpio : gpio pins in order control ktd2692 flash led.
>> + There is an internal 300kOhm pull-down resistor at each pin
>> + - vin-supply : "vin" LED supply (2.7V to 5.5V)
>> + See Documentation/devicetree/bindings/regulator/regulator.txt
>> +
>
> Above bindings are not that readable to me. Remove the tab spaces before properties.
>

Isn't it clear?
OK, I'll fix it more

>> +Optional property:
>> + - flash-timeout-us : Maximum flash timeout in microseconds.
>> + flash timeout ranges from 0 to 1835000us and
>> + default is 1049000us.
>> +
>> +Example:
>> +
>> +flash-led {
>> + compatible = "kinetic,ktd2692";
>> + ctrl-gpio = <&gpc0 1 0>;
>> + aux-gpio = <&gpc0 2 0>;
>> + flash-timeout-us = <1835000>;
>> + vin-supply = <&vbat>;
>> +};
>
>


\
 
 \ /
  Last update: 2015-03-26 03:01    [W:0.052 / U:1.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site