lkml.org 
[lkml]   [2015]   [Mar]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: clk: dt: bindings for mux-clock
Am 22.03.2015 um 18:10 schrieb Michael Turquette:
> Quoting Sergej Sawazki (2015-03-19 14:50:50)
>> Hi Mike,
>>
>> I came across your "[PATCH v2 0/5] clk: dt: bindings for mux, divider &
>> gate clocks" email from 16 Jun 2013. The DT bindings for simple clock
>> multiplexers would be very helpful for a board I am working on. Do you
>> see any chance to get it into mainline?
>
> Hi Sergej,
>
> I abandoned those binding a while back. The reason is that those are
> one-node-per-clock bindings, which are unpopular with the DT crowd.
> Instead most bindings today use a single node to represent a clock
> provider, which maps onto a clock driver in Linux.
>
> Is your clock provider made up of only a single clock? If so then the
> bindings you mentioned above may be appropriate. But if you have a clock
> controller IP block that manages several clocks then it is better for
> you to follow the clock provider binding style. There is no shortage of
> good examples on how to do this. See the QCOM, Samsung and Nvidia
> bindings for ideas.
>
> Regards,
> Mike
>
>>
>> Many thanks in advance!
>> Regards,
>> Sergej
Hi Mike, many thanks for your answer.

My clock provider is made up of two external oscillators and an
external clock multiplexer. The clock multiplexer has two inputs and
one output. See IDT 853S01I for example. The oscillators are connected
to the multiplexer inputs. The clock consumer is connected to the
output of the multiplexer. The multiplexer is controlled by a gpio to
select one of the oscillators.

Based on clk-gpio-gate.c, I am considering to develop a driver for a
gpio controlled clock multiplexer. Do you think it makes sense? Or
should I choose a different approach?

Regards,
Sergej



\
 
 \ /
  Last update: 2015-03-25 20:41    [W:0.094 / U:0.772 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site