lkml.org 
[lkml]   [2015]   [Feb]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    SubjectRe: [PATCH] PCI: Fix pcibios_update_irq misuse of irq number
    Date
    On Tuesday 03 February 2015 10:38:25 Marc Zyngier wrote:
    >
    > That's exactly what I thought until Lorenzo reported kvmtool falling
    > over because of this write. Obviously, some platforms must actually
    > require this (possibly for bridges that are not known by the firmware).

    This sounds much like a bug in kvmtool.

    > Entirely removing that code solves my problem too, but that'd cannot be
    > the right solution...

    The comment in pdev_fixup_irq() says

    /* Always tell the device, so the driver knows what is
    the real IRQ to use; the device does not use it. */

    which I read to mean that there are drivers that incorrectly use
    'pci_read_config_byte(dev, PCI_INTERRUPT_LINE)' as the number
    they pass into request_irq, rather than using dev->irq.
    However, this means that your patch is actually wrong, because
    what the driver cares about is the virtual irq number (which
    request_irq expects), not the number relative to some interrupt
    controller.

    There is another comment in include/linux/pci.h that states
    /*
    * Instead of touching interrupt line and base address registers
    * directly, use the values stored here. They might be different!
    */
    unsigned int irq;

    so apparently this has been a cause for problems in the past,
    and drivers that rely on the number are already broken.

    I also checked ancient kernel versions from the 2.1 days when the
    code was first added. And indeed at the time drivers used to read
    the word, but now none of them use the number for anything real,
    they were all fixed during linux-2.2 at the latest.

    Arnd


    \
     
     \ /
      Last update: 2015-02-03 12:41    [W:8.187 / U:0.100 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site