Messages in this thread | | | Date | Thu, 26 Feb 2015 09:09:55 -0500 | From | Peter Hurley <> | Subject | Re: [PATCH v3 3/3] of: support passing console options with stdout-path |
| |
Hi Andrew,
On 02/26/2015 08:46 AM, Andrew Lunn wrote: > On Thu, Feb 26, 2015 at 06:55:22AM -0500, Peter Hurley wrote: >> On 11/27/2014 12:56 PM, Leif Lindholm wrote: >>> Support specifying console options (like with console=ttyXN,<options>) >>> by appending them to the stdout-path property after a separating ':'. >>> >>> Example: >>> stdout-path = "uart0:115200"; >> >> This format breaks DT earlycon because libfdt doesn't recognize ':' as a >> path terminator. >> >> It's simple enough to fix this directly in early_init_dt_scan_chosen_serial() >> but perhaps it would better to teach fdt_path_offset() to recognize ':'? > > Hi Peter > > ePAPR says for stdout-path in Chosen: > > A string that specifies the full path to the node representing the > device to be used for boot console output. If the character ":" is > present in the value it terminates the path. The value may be an > alias. > > So it is probably wise to implement this properly.
Sorry if I was unclear. My question was not _whether_ to fix this for earlycon, but rather _how_.
IOW, is the ':' character accepted as a path terminator for 1. all nodes, so fix this in fdt_path_offset(); 2. only chosen nodes; 3. unique to stdout-path, so fix this in early_init_dt_scan_chosen_serial()?
Regards, Peter Hurley
| |