lkml.org 
[lkml]   [2015]   [Dec]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/3] ata: sata_dwc_460ex: use "dmas" DT property to find dma channel
From
On Sun, Dec 20, 2015 at 7:11 PM, Måns Rullgård <mans@mansr.com> wrote:
> Julian Margetson <runaway@candw.ms> writes:
>
>> On 12/19/2015 4:41 PM, Måns Rullgård wrote:
>>> Andy Shevchenko <andy.shevchenko@gmail.com> writes:
>>>
>>>> On Sat, Dec 19, 2015 at 10:16 PM, Julian Margetson <runaway@candw.ms> wrote:
>>>>> On 12/19/2015 3:07 PM, Måns Rullgård wrote:
>>>>>> Julian Margetson <runaway@candw.ms> writes:

>> [ 18.606292] dma dma0chan0: dwc_tx_submit: queued 2
>> [ 18.611091] dma dma0chan0: dwc_dostart_first_queued: started 2
>> [ 48.748614] ata3: lost interrupt (Status 0x40)
>
> Now we're getting somewhere. The dma transfer is set up and initiated,
> but then nothing happens. Comparing the old sata_dwc driver, from
> before the switch to dmaengine, with the dw_dma driver, I noticed an
> obvious problem: the descriptors are filled in using the wrong byte
> order.

So, it means we have IO in little endian, but DMA reads data from
memory in big endian?

> This patch might fix that.

In case it works I have to test it on AVR32.

--
With Best Regards,
Andy Shevchenko


\
 
 \ /
  Last update: 2015-12-20 19:01    [W:1.473 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site