Messages in this thread Patch in this message | | | From | Srinivas Kandagatla <> | Subject | [PATCH 1/4] ARM: dts: qcom: apq8064-ifc6410 Use hardware flow control for GSBI6 | Date | Fri, 11 Dec 2015 18:29:58 +0000 |
| |
From: "Ivan T. Ivanov" <ivan.ivanov@linaro.org>
GSBI6 UART module is connected to BT chip, which uses hardware flow control lines. Enable them on SoC side.
Signed-off-by: Ivan T. Ivanov <ivan.ivanov@linaro.org> --- arch/arm/boot/dts/qcom-apq8064-ifc6410.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts index 11ac608..80c6695 100644 --- a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts +++ b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts @@ -164,7 +164,7 @@ gsbi@16500000 { status = "ok"; - qcom,mode = <GSBI_PROT_I2C_UART>; + qcom,mode = <GSBI_PROT_UART_W_FC>; serial@16540000 { status = "ok"; -- 1.9.1
| |