lkml.org 
[lkml]   [2015]   [Dec]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] arm64: dts: set the default i2c pin drive strength to 16mA
Date
2mA drive strength is not enough when we connect multiple i2c devices
on the bus with different pull up resistors.

This issue was detected when multiple i2c devices connected on the other side
of level shifters on Linaro sensor board. Maxing up to 16mA made i2c much stable.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
---
arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
index 49ec55a..1991af7 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
@@ -272,7 +272,7 @@
};
pinconf {
pins = "gpio6", "gpio7";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable = <0>;
};
};
@@ -296,7 +296,7 @@
};
pinconf {
pins = "gpio14", "gpio15";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable = <0>;
};
};
@@ -320,7 +320,7 @@
};
pinconf {
pins = "gpio22", "gpio23";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable = <0>;
};
};
--
1.9.1


\
 
 \ /
  Last update: 2015-12-11 19:41    [W:0.024 / U:0.804 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site