lkml.org 
[lkml]   [2015]   [Nov]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/5] spi: spi-ti-qspi: add mmap mode read support
From
Date


On 11/04/2015 08:11 PM, Mark Brown wrote:
> On Tue, Nov 03, 2015 at 03:36:11PM +0530, Vignesh R wrote:
>
>> + ti_qspi_enable_memory_map(spi);
>> + ti_qspi_setup_mmap_read(spi, read_opcode, addr_width,
>> + dummy_bytes);
>> + memcpy_fromio(buf, qspi->mmap_base + from, len);
>> + *retlen = len;
>> + ti_qspi_disable_memory_map(spi);
>
> We'll be constantly enabling and disabling memory mapping with this.
> I'm not sure that's a meaningful cost given that it doesn't actually
> remap anything but rather just switches hardware modes, we can always
> optimise it later if it is.
>

Hmm, I will move the ti_qspi_disable_memory_map() call to
ti_qspi_start_transfer_one(), so that mmap mode is disabled only when
normal SPI bus transfer is requested. Further, "mmap_enabled" status
flag can be used to determine whether mode switch is required or not.
This should help to overcome enabling and disabling memory mapping
between successive mmap read requests.

--
Regards
Vignesh


\
 
 \ /
  Last update: 2015-11-05 07:41    [W:0.053 / U:0.536 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site