lkml.org 
[lkml]   [2015]   [Nov]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 02/12] staging: rtl8188eu: return value and argument types changed in _rtl88e_write_fw function
From
Date
On 11/09/2015 03:24 AM, Andy Shevchenko wrote:
> On Sun, Nov 8, 2015 at 1:26 PM, Ivan Safonov <insafonov@gmail.com> wrote:
>> On 11/08/2015 05:11 PM, Andy Shevchenko wrote:
>>> On Sun, Nov 8, 2015 at 8:37 AM, Ivan Safonov <insafonov@gmail.com> wrote:
>>>> Ideally the function should not change the variables outside of its body.
>>>> -static void _rtl88e_fill_dummy(u8 *pfwbuf, u32 *pfwlen)
>>>> +static u32 _rtl88e_fill_dummy(u8 *pfwbuf, u32 pfwlen)
>>>> {
>>>> u32 i;
>>>>
>>>> - for (i = *pfwlen; i < roundup(*pfwlen, 4); i++)
>>>> + for (i = pfwlen; i < roundup(pfwlen, 4); i++)
>>>> pfwbuf[i] = 0;
>>> memset() ?
>>>
>>>> - *pfwlen = i;
>>>> + return i;
>>>> }
>>>>
>>>> static void _rtl88e_fw_page_write(struct adapter *adapt,
>>>> @@ -103,7 +103,7 @@ static void _rtl88e_write_fw(struct adapter *adapt,
>>>> u8 *buffer, u32 size)
>>>> u32 page_no, remain;
>>>> u32 page, offset;
>>>>
>>>> - _rtl88e_fill_dummy(buf_ptr, &size);
>>>> + size = _rtl88e_fill_dummy(buf_ptr, size);
>
>> memset applied in another patch. Here only replacement of the function type.
> Since it's used only once it would be nice to replace it by plain
> memset() in one patch.
>

I doubt its usefulness.
Perhaps, this function is not needed because firmware copied byte by byte.
It is function for firmware uploading (I don't know why it is so
written, but in the case of the size of the firmware a multiple of 4, it
can be easier):
static void _rtl88e_fw_block_write(struct adapter *adapt,
const u8 *buffer, u32 size)
{
u32 blk_sz = sizeof(u32);
const u8 *byte_buffer;
const u32 *dword_buffer = (u32 *)buffer;
u32 i, write_address, blk_cnt, remain;

blk_cnt = size / blk_sz;
remain = size % blk_sz;

write_address = FW_8192C_START_ADDRESS;

for (i = 0; i < blk_cnt; i++, write_address += blk_sz)
usb_write32(adapt, write_address, dword_buffer[i]);

byte_buffer = buffer + blk_cnt * blk_sz;
for (i = 0; i < remain; i++, write_address++)
usb_write8(adapt, write_address, byte_buffer[i]);
}


\
 
 \ /
  Last update: 2015-11-10 10:41    [W:0.027 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site