Messages in this thread | | | Date | Sun, 1 Nov 2015 07:42:29 +0100 | From | Wolfram Sang <> | Subject | Re: [PATCH 2/2] i2c: add driver for Sigma Designs SMP8642 I2C master |
| |
On Sat, Oct 31, 2015 at 05:35:57PM +0000, Mans Rullgard wrote: > This adds a driver for the Sigma Designs SMP8642 built-in I2C master > controller. The hardware is very similar to the I2C controller in the > Ralink RT3050 chip with the addition of interrupt generation and an > inverted busy/idle status bit. There are typically two controllers with > a shared IRQ. > > Signed-off-by: Mans Rullgard <mans@mansr.com>
Thanks for the driver. Same answer as here, though:
http://www.spinics.net/lists/linux-i2c/msg17001.html
> +#define TANGOX_I2C_CONFIG 0x00 > +#define TANGOX_I2C_CLKDIV 0x04 > +#define TANGOX_I2C_DEVADDR 0x08 > +#define TANGOX_I2C_ADDR 0x0c > +#define TANGOX_I2C_DATAOUT 0x10 > +#define TANGOX_I2C_DATAIN 0x14 > +#define TANGOX_I2C_STATUS 0x18 > +#define TANGOX_I2C_STARTXFER 0x1c > +#define TANGOX_I2C_BYTECNT 0x20 > +#define TANGOX_I2C_INT_EN 0x24 > +#define TANGOX_I2C_INT_STAT 0x28
The register set looks like the one from i2c-xlr.c, only that they are 32 bit apart instead of 8. Can you check if you can reuse that driver?
Thanks,
Wolfram
[unhandled content-type:application/pgp-signature] | |