Messages in this thread Patch in this message | | | From | Caesar Wang <> | Subject | [PATCH 3/4] thermal: rockchip: change the TSHUT default state | Date | Tue, 20 Oct 2015 17:11:03 +0800 |
| |
As the TRM says, the TSHUT default state is high active. In general, the TSHUT state can get from the dts. Otherwise it gets the state from this.
Signed-off-by: Caesar Wang <wxt@rock-chips.com> ---
drivers/thermal/rockchip_thermal.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/thermal/rockchip_thermal.c b/drivers/thermal/rockchip_thermal.c index c53e318..776d668 100644 --- a/drivers/thermal/rockchip_thermal.c +++ b/drivers/thermal/rockchip_thermal.c @@ -326,7 +326,7 @@ static void rk_tsadcv2_tshut_mode(int chn, void __iomem *regs, static const struct rockchip_tsadc_chip rk3288_tsadc_data = { .tshut_mode = TSHUT_MODE_GPIO, /* default TSHUT via GPIO give PMIC */ - .tshut_polarity = TSHUT_LOW_ACTIVE, /* default TSHUT LOW ACTIVE */ + .tshut_polarity = TSHUT_HIGH_ACTIVE, /* default TSHUT HIGH ACTIVE */ .tshut_temp = 95000, .initialize = rk_tsadcv2_initialize, -- 1.9.1
| |