lkml.org 
[lkml]   [2015]   [Jan]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/4] ARM: tegra: rely on bootloader pinmux programming on nyan-big
On 01/06/2015 03:37 AM, Tomeu Vizoso wrote:
> Following 6dbaff2b, the kernel expects that the bootloader has correctly
> programmed the Tegra pinmux.
>
> DTs for the Jetson and the Venice2 had been updated already but this one
> was left behind.

So this setup is true for NVIDIA-controlled development/reference boards
where we've ensured that the bootloader sets up 100% of the pinmux.

However, I know that Coreboot on this board doesn't set up everything in
the pinmux, and since it's in r/o flash never will. As such, I'm not
sure this change is safe for this board. That is, unless you want to
force upstream kernels to be booted via a chain-loaded path: Coreboot
(r/o) -> U-Boot (r/w with full pinmux setup) -> kernel.

> Have tested this with the stock vendor firmware (coreboot) and have found no
> issues.

There are presumably a bunch of features which aren't yet supported
upstream, and hence you couldn't test though? That means we might find
that parts of the pinmux aren't yet programmed but need to be to enable
those features.


\
 
 \ /
  Last update: 2015-01-06 18:41    [W:0.122 / U:0.188 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site