lkml.org 
[lkml]   [2015]   [Jan]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 08/10] ARM: tegra: Use pwrseq-simple for the wifi in Nyan
Date
The Nyan boards have a Marvell 88w8897 wifi card connected through SDIO
that needs the reset line to be asserted before mmc power up and deasserted
afterwards.

This patch also adds references to the power supplies of the card so that
the regulators are enabled when it's probed.

Signed-off-by: Tomeu Vizoso <tomeu.vizoso@collabora.com>
---
arch/arm/boot/dts/tegra124-nyan.dtsi | 11 +++++++++--
1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/tegra124-nyan.dtsi b/arch/arm/boot/dts/tegra124-nyan.dtsi
index 26e7402..632d181 100644
--- a/arch/arm/boot/dts/tegra124-nyan.dtsi
+++ b/arch/arm/boot/dts/tegra124-nyan.dtsi
@@ -207,7 +207,6 @@
regulator-name = "+1.8V_VDDIO";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
- regulator-boot-on;
regulator-always-on;
};

@@ -364,12 +363,20 @@
status = "okay";
};

+ sdhci0_pwrseq: sdhci0_pwrseq {
+ compatible = "mmc-pwrseq-simple";
+
+ reset-gpios = <&gpio TEGRA_GPIO(X, 7) GPIO_ACTIVE_LOW>;
+ };
+
sdhci@0,700b0000 { /* WiFi/BT on this bus */
status = "okay";
- power-gpios = <&gpio TEGRA_GPIO(X, 7) GPIO_ACTIVE_HIGH>;
bus-width = <4>;
no-1-8-v;
non-removable;
+ mmc-pwrseq = <&sdhci0_pwrseq>;
+ vmmc-supply = <&vdd_3v3_lp0>;
+ vqmmc-supply = <&vddio_1v8>;
};

sdhci@0,700b0400 { /* SD Card on this bus */
--
1.9.3


\
 
 \ /
  Last update: 2015-01-29 04:21    [W:0.152 / U:0.520 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site