lkml.org 
[lkml]   [2015]   [Jan]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 2/3] i2c: iproc: Add Broadcom iProc I2C Driver
Hello,

On Fri, Jan 16, 2015 at 02:09:28PM -0800, Ray Jui wrote:
> On 1/15/2015 12:41 AM, Uwe Kleine-König wrote:
> > On Wed, Jan 14, 2015 at 02:23:32PM -0800, Ray Jui wrote:
> >> + */
> >> + val = 1 << M_CMD_START_BUSY_SHIFT;
> >> + if (msg->flags & I2C_M_RD) {
> >> + val |= (M_CMD_PROTOCOL_BLK_RD << M_CMD_PROTOCOL_SHIFT) |
> >> + (msg->len << M_CMD_RD_CNT_SHIFT);
> >> + } else {
> >> + val |= (M_CMD_PROTOCOL_BLK_WR << M_CMD_PROTOCOL_SHIFT);
> >> + }
> >> + writel(val, iproc_i2c->base + M_CMD_OFFSET);
> >> +
> >> + time_left = wait_for_completion_timeout(&iproc_i2c->done, time_left);
> >
> > When the interrupt fires here after the complete timed out and before
> > you disable the irq you still throw the result away.
> Yes, but then this comes down to the fact that if it has reached the
> point that is determined to be a timeout condition in the driver, one
> should really treat it as timeout error. In a normal condition,
> time_left should never reach zero.
I don't agree here. I'm not sure there is a real technical reason,
though. But still if you're in a "success after timeout already over"
situation it's IMHO better to interpret it as success, not timeout.

> >> +static int bcm_iproc_i2c_remove(struct platform_device *pdev)
> >> +{
> >> + struct bcm_iproc_i2c_dev *iproc_i2c = platform_get_drvdata(pdev);
> >> +
> >> + i2c_del_adapter(&iproc_i2c->adapter);
> > You need to free the irq before i2c_del_adapter.
> >
> Yes. Thanks. Change back to use devm_request_irq, and use disable_irq
> here before removing the adapter.
The more lightweight approach is to set your device's irq-enable
register to zero and call synchronize_irq. (For a shared irq calling
disable_irq is even wrong here.)

Best regards
Uwe

--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |


\
 
 \ /
  Last update: 2015-01-17 17:21    [W:0.096 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site