lkml.org 
[lkml]   [2014]   [Sep]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: WARNING in block layer triggered in 3.17-rc3
From
On Sat, Sep 6, 2014 at 1:45 AM, Alan Stern <stern@rowland.harvard.edu> wrote:
> James and Jens:
>
> I got a WARNING when unbinding the sd driver from a USB flash drive and
> then binding it back again. Here's where the flash drive gets probed
> initially:
>
> [ 143.300886] usb-storage 4-8:1.0: usb_probe_interface
> [ 143.300911] usb-storage 4-8:1.0: usb_probe_interface - got id
> [ 143.300930] usb-storage 4-8:1.0: USB Mass Storage device detected
> [ 143.318239] scsi host0: usb-storage 4-8:1.0
> [ 143.359979] scsi 0:0:0:0: Direct-Access Ut165 USB2FlashStorage 0.00 PQ: 0 ANSI: 2
> [ 143.376366] usbcore: registered new interface driver usb-storage
> [ 143.468464] sd 0:0:0:0: [sda] 7892040 512-byte logical blocks: (4.04 GB/3.76 GiB)
> [ 143.481725] sd 0:0:0:0: [sda] Write Protect is off
> [ 143.485712] sd 0:0:0:0: [sda] Mode Sense: 00 00 00 00
> [ 143.487064] sd 0:0:0:0: [sda] Asking for cache data failed
> [ 143.498428] sd 0:0:0:0: [sda] Assuming drive cache: write through
> [ 143.656797] sda: sda1
> [ 143.676922] sd 0:0:0:0: [sda] Attached SCSI removable disk
>
> Then I did
>
> echo 0:0:0:0 >/sys/bus/scsi/drivers/sd_mod/unbind
>
> followed by
>
> echo 0:0:0:0 >/sys/bus/scsi/drivers/sd_mod/bind

I can reproduce it on virtio-blk too with scsi-mq, and can't duplicate
it on non-scsi devices, so looks there are refcounts leak in scsi subsystem?


Thanks,
--
Ming Lei


\
 
 \ /
  Last update: 2014-09-07 13:21    [W:0.073 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site