lkml.org 
[lkml]   [2014]   [Sep]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/3] Documentation: dt: input: tsc2007: Document new parameters
Date
Signed-off-by: Marek Belisko <marek@goldelico.com>
---
.../devicetree/bindings/input/touchscreen/tsc2007.txt | 17 ++++++++++++++---
1 file changed, 14 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt b/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt
index ec365e1..46b086c 100644
--- a/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt
+++ b/Documentation/devicetree/bindings/input/touchscreen/tsc2007.txt
@@ -13,14 +13,25 @@ Optional properties:
(see interrupt binding[0]).
- interrupts: (gpio) interrupt to which the chip is connected
(see interrupt binding[0]).
-- ti,max-rt: maximum pressure.
+- ti,swap-xy: if present, swap x and y values. Rotation left/right is
+ achieved by combination with flipping of x or y.
+- ti,min-x: minimum x (default 0). Use this for a coarse calibration of the
+ touch if there is no user space option (e.g. Android, X11).
+- ti,max-x: maximum x (default 4095). If max-x is smaller than min-x the
+ axis is swapped.
+- ti,min-y: minimum y (default 0).
+- ti,max-y: maximum y (default 4095).
+- ti,min-rt: minimum pressure (default 0).
+- ti,max-rt: maximum pressure (default 4095). Depending on your needs, you
+ can also invert the pressure value since the raw rt value reports the
+ resistance and not the "pressure" (i.e. becomes lower for higher pressure).
- ti,fuzzx: specifies the absolute input fuzz x value.
If set, it will permit noise in the data up to +- the value given to the fuzz
- parameter, that is used to filter noise from the event stream.
+ parameter, that is used to filter noise from the event stream (default 0).
- ti,fuzzy: specifies the absolute input fuzz y value.
- ti,fuzzz: specifies the absolute input fuzz z value.
- ti,poll-period: how much time to wait (in milliseconds) before reading again the
- values from the tsc2007.
+ values from the tsc2007 (default 1).

[0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
[1]: Documentation/devicetree/bindings/gpio/gpio.txt
--
1.9.3


\
 
 \ /
  Last update: 2014-09-30 23:01    [W:0.176 / U:0.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site