Messages in this thread | | | Date | Fri, 12 Sep 2014 18:55:46 +0300 | From | Dmitry Lavnikevich <> | Subject | Re: [PATCH 1/5] ARM: dts: pbab01: move i2c pins and frequency configuration into pfla02 |
| |
On 11/09/14 11:47, Philipp Zabel wrote: > Am Mittwoch, den 10.09.2014, 16:46 +0300 schrieb Dmitry Lavnikevich: >> Since pins and frequency are specific to module (pfla02), not base board >> (pbab02), it is better to be initialized in corresponding dts file. >> >> Signed-off-by: Dmitry Lavnikevich <d.lavnikevich@sam-solutions.com> > I have seen boards use the GPIO_3/6 pads instead of EIM_D17/D18 for > I2C3, but the EIM_D17/D18 are indeed documented as "I2C1" pins at the > pfla02 connector level. > > regards > Philipp > Yes, that is why I thought about moving it into pfla02. But apart from it, i2c2grp i2c3grp nodes was wrongly placed under iomuxc node while it should be grouped inside of it, like in imx6q-phytec-pfla02 to which it was moved with this patch. Because of this specified i2c wasn't working correctly and caused messages:
imx6q-pinctrl 20e0000.iomuxc: no groups defined in /soc/aips-bus@02000000/iomuxc@020e0000/i2c2grp imx6q-pinctrl 20e0000.iomuxc: no groups defined in /soc/aips-bus@02000000/iomuxc@020e0000/i2c3grp imx6q-pinctrl 20e0000.iomuxc: unable to find group for node i2c2grp imx6q-pinctrl 20e0000.iomuxc: unable to find group for node i2c3grp
Added this into commit message with new patchset.
Best regards, Lavnikevich Dmitry
| |