lkml.org 
[lkml]   [2014]   [Aug]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [Xen-devel] [PATCH] xen-netback: Turn off the carrier if the guest is not able to receive
On 04/08/14 14:35, David Vrabel wrote:
> On 30/07/14 20:50, Zoltan Kiss wrote:
>> Currently when the guest is not able to receive more packets, qdisc layer starts
>> a timer, and when it goes off, qdisc is started again to deliver a packet again.
>> This is a very slow way to drain the queues, consumes unnecessary resources and
>> slows down other guests shutdown.
>> This patch change the behaviour by turning the carrier off when that timer
>> fires, so all the packets are freed up which were stucked waiting for that vif.
>> Instead of the rx_queue_purge bool it uses the VIF_STATUS_RX_PURGE_EVENT bit to
>> signal the thread that either the timout happened or an RX interrupt arrived, so
>> the thread can check what it should do. It also disables NAPI, so the guest
>> can't transmit, but leaves the interrupts on, so it can resurrect.
>
> I don't think you should disable NAPI, particularly since you have to
> fiddle with the bits directly instead of usign the API to do so.
Since then I've found a much better way, see xenvif_poll.
>
> I looked at some hardware drivers and none of them disabled NAPI -- they
> just allow it to naturally end once hardware queues are drained.
>
> netback is a little different as a frontend could stop processing
> to-guest packets but continue sending from-guest ones. I don't see any
> problem with allowing this.
Yes, that might be the case. Just a hunch tells me that could be wrong,
but I couldn't come up with a scenario to prove it. Let's hear other's
opinion about it:
Is it good or bad if a guest interface with carrier off still keeps
sending packets towards the backend? Hardware drivers are trusted that
when carrier goes down there won't be new packets (apart from a few
still in the receive queue of the driver), so NAPI will be automatically
descheduled. But in this scenario the guest could still post new packets
on the ring, and they will be received unless NAPI is explicitly
descheduled.

>
>> @@ -1955,24 +1955,78 @@ int xenvif_kthread_guest_rx(void *data)
>> */
>> if (unlikely(queue->vif->disabled && queue->id == 0))
>> xenvif_carrier_off(queue->vif);
>> + else if (unlikely(test_and_clear_bit(QUEUE_STATUS_RX_PURGE_EVENT,
>> + &queue->status))) {
>> + /* Either the last unsuccesful skb or at least 1 slot
>> + * should fit
>> + */
>> + int needed = queue->rx_last_skb_slots ?
>> + queue->rx_last_skb_slots : 1;
>>
>> - if (kthread_should_stop())
>> - break;
>> -
>> - if (queue->rx_queue_purge) {
>> + /* It is assumed that if the guest post new
>> + * slots after this, the RX interrupt will set
>> + * the bit and wake up the thread again
>> + */
>> + set_bit(QUEUE_STATUS_RX_STALLED, &queue->status);
>
> This big if needs to go in a new function.
>
> David
>



\
 
 \ /
  Last update: 2014-08-04 17:41    [W:0.100 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site