lkml.org 
[lkml]   [2014]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Lattice ECP3 FPGA with i.MX6
On 03.07.2014 14:37, Jean-Michel Hautbois wrote:
> I have a board, with a Freescale i.MX6 chip and a ECP3-35 FPGA on SPI.
> I tried to load the firmware using the lattice-ecp3-config driver, but
> it fails with this error :
>
> lattice-ecp3 spi32766.3: FPGA bitstream configuration driver registered
> lattice-ecp3 spi32766.3: Error: No supported FPGA detected (JEDEC_ID=808004c2)!
>
> In the driver, the id is :
>
> #define ID_ECP3_35 0xc2048080
>
> Obviously, there is a big/little endian issue... Do I need to instruct
> the device-tree in a specific way in order to get the bus in the
> correct order ? Or is this a known issue maybe ?

No. This driver was implemented and tested in a MPC5200 system. Most
likely I missed some endian issues as you already noticed. I suggest you
start with looking at this line:

jedec_id = *(u32 *)&rxbuf[4];

And add some endian functions here, e.g. be32_to_cpu(). This might help
with the detection. But other endian related issues might still be
present in other parts of the driver as well.

HTP.

Thanks,
Stefan



\
 
 \ /
  Last update: 2014-07-03 15:21    [W:0.046 / U:0.568 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site