lkml.org 
[lkml]   [2014]   [Jul]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v8 02/11] power: reset: Add reboot driver for brcmstb
Date
On Monday 21 July 2014 14:07:57 Brian Norris wrote:
> diff --git a/arch/arm/mach-bcm/Kconfig b/arch/arm/mach-bcm/Kconfig
> index 0073633e7699..9782e8d80647 100644
> --- a/arch/arm/mach-bcm/Kconfig
> +++ b/arch/arm/mach-bcm/Kconfig
> @@ -94,6 +94,7 @@ config ARCH_BRCMSTB
> select MIGHT_HAVE_PCI
> select HAVE_SMP
> select HAVE_ARM_ARCH_TIMER
> + select POWER_RESET_BRCMSTB
> help
> Say Y if you intend to run the kernel on a Broadcom ARM-based STB
> chipset.
> diff --git a/drivers/power/reset/Kconfig b/drivers/power/reset/Kconfig
> index bdcf5173e377..fcb9825debe5 100644
> --- a/drivers/power/reset/Kconfig
> +++ b/drivers/power/reset/Kconfig
> @@ -20,6 +20,16 @@ config POWER_RESET_AXXIA
>
> Say Y if you have an Axxia family SoC.
>
> +config POWER_RESET_BRCMSTB
> + bool "Broadcom STB reset driver"
> + depends on POWER_RESET && ARCH_BRCMSTB
> + help
> + This driver provides restart support for ARM-based Broadcom STB
> + boards.
> +
> + Say Y here if you have an ARM-based Broadcom STB board and you wish
> + to have restart support.
> +
> config POWER_RESET_GPIO
> bool "GPIO power-off driver"
> depends on OF_GPIO && POWER_RESET
>

(nitpicking)

You shouldn't have both a user-selectable option and 'select' it from
the platform, because it makes it inherently not selectable, in particular
in the combination with 'depends on ARCH_BRCMSTB'.

One way to solve this would be to change the dependency to

config POWER_RESET_BRCMSTB
bool "Broadcom STB reset driver"
depends on POWER_RESET && ARM
depends on ARCH_BRCMSTB || COMPILE_TEST

which in effect would allow building it on any ARM machine as long as
COMPILE_TEST is set (which normally is not).

The same could be expressed using

config POWER_RESET_BRCMSTB
bool "Broadcom STB reset driver" if COMPILE_TEST
depends on POWER_RESET && ARM

My preference in this case however would be to just drop the 'select'
statement and add the driver to the defconfig file.

Arnd


\
 
 \ /
  Last update: 2014-07-22 10:21    [W:0.257 / U:2.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site