lkml.org 
[lkml]   [2014]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 2/4] usb: host: xhci-plat: Get PHYs for xhci's hcds
On Wed, Jul 16, 2014 at 01:51:40PM +0530, Vivek Gautam wrote:
> The host controller by itself may sometimes need to handle PHY
> and/or calibrate some of the PHY settings to get full support out
> of the PHY controller. The PHY core provides a calibration
> funtionality now to do so.
> Therefore, facilitate getting the two possible PHYs, viz.
> USB 2.0 type (UTMI+) and USB 3.0 type (PIPE3).
>
> Signed-off-by: Vivek Gautam <gautam.vivek@samsung.com>
> ---
>
> Changes from v3:
> - Modified error message as per review comments from Julius.
>
> drivers/usb/host/xhci-plat.c | 19 +++++++++++++++++++
> 1 file changed, 19 insertions(+)
>
> diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
> index 1a0cf9f..b1c0364 100644
> --- a/drivers/usb/host/xhci-plat.c
> +++ b/drivers/usb/host/xhci-plat.c
> @@ -16,6 +16,7 @@
> #include <linux/module.h>
> #include <linux/of.h>
> #include <linux/platform_device.h>
> +#include <linux/phy/phy.h>
> #include <linux/slab.h>
> #include <linux/usb/xhci_pdriver.h>
>
> @@ -180,6 +181,15 @@ static int xhci_plat_probe(struct platform_device *pdev)
> goto put_hcd;
> }
>
> + /* Get possile USB 2.0 type PHY (UTMI+) available with xhci */
> + hcd->gen_phy = devm_phy_get(&pdev->dev, "usb2-phy");
> + if (IS_ERR(hcd->gen_phy)) {
> + ret = PTR_ERR(hcd->gen_phy);
> + if (ret != -ENOSYS && ret != -ENODEV)
> + dev_warn(&pdev->dev,
> + "Error retrieving usb2 phy: %d\n", ret);
> + }

should you treat -EPROBE_DEFER differently here ?

--
balbi
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2014-07-16 23:21    [W:0.035 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site