lkml.org 
[lkml]   [2014]   [May]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: IPMI misbehaving on ARM defconfigs, was [Re: stable boot: 18 pass, 4 fail (v3.10.39)]
Date
On Wednesday 07 May 2014 10:20:56 Jason Cooper wrote:
> > ipmi message handler version 39.2
> > IPMI System Interface driver.
> > ipmi_si: Adding default-specified kcs state machine
> > ipmi_si: Trying default-specified kcs state machine at i/o address 0xca2, slave address 0x0, irq 0
> > ipmi_si: Could not set up I/O space
> > Trying to free nonexistent resource <0000000000000ca2-0000000000000ca2>
> > Trying to free nonexistent resource <0000000000000ca3-0000000000000ca3>
> > ipmi_si: Adding default-specified smic state machine
> > ipmi_si: Trying default-specified smic state machine at i/o address 0xca9, slave address 0x0, irq 0
> > ipmi_si: Could not set up I/O space
> > Trying to free nonexistent resource <0000000000000ca9-0000000000000ca9>
> > Trying to free nonexistent resource <0000000000000caa-0000000000000caa>
> > Trying to free nonexistent resource <0000000000000cab-0000000000000cab>
> > ipmi_si: Adding default-specified bt state machine
> > ipmi_si: Trying default-specified bt state machine at i/o address 0xe4, slave address 0x0, irq 0
> > ipmi_si: Could not set up I/O space
> > Trying to free nonexistent resource <00000000000000e4-00000000000000e4>
> > Trying to free nonexistent resource <00000000000000e5-00000000000000e5>
> > Trying to free nonexistent resource <00000000000000e6-00000000000000e6>
> > ipmi_si: Unable to find any System Interface(s)
> > Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
> ...
>
> It appears to be unrelated to the failure this original message was
> about. However, the failure brought the above to our attention.
>
> Is the IPMI driver used on ARM? Documentation/IPMI.txt indicates a
> dependency on ACPI, but that isn't reflected in the Kconfig. At any
> rate, it seems rather unhappy. :(

It certainly can be used, and it can be probed through a known PC-style
port number or through the DT binding.

However, we don't normally want it to try the PC style addresses, which
appear to be used in this case. This should only happen if
CONFIG_IPMI_SI_PROBE_DEFAULTS is set, as far as I can tell. Is that
set in your configuration?

Arnd


\
 
 \ /
  Last update: 2014-05-07 17:41    [W:0.089 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site