lkml.org 
[lkml]   [2014]   [May]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] PCI/shpchp: fix a bus speed issue on hotplug
On 05/01/2014 05:35 PM, Marcel Apfelbaum wrote:
> When a board is added, the shpchp driver checks if there
> is a mismatch between the bridge's adapter and the bus speed.
> If there is, it sets the subordinate speed (if there is no device on it).

Since the speed is irrelevant when running in a VM, I suggest that
you either ignore it altogether, or "normalize" the speed of all the
devices/bridges/buses in QEMU in order to avoid any conflicts
in the first place.

Thanks, Ronen.

>
> However, it takes the reference of the board speed from the primary bus
> and not from the subordinate. If the primary bus is PCI and not PCIX/PCIe,
> its speed is not updated and remains 0xff. As a result hotplug fails
> with error: "Speed of bus ff and adapter 0 mismatch".
>
> Fixed that by checking the speed against the subordinate bus.
>
> Signed-off-by: Marcel Apfelbaum <marcel.a@redhat.com>
> Acked-by: Michael S. Tsirkin <mst@redhat.com>
> ---
> drivers/pci/hotplug/shpchp_ctrl.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pci/hotplug/shpchp_ctrl.c b/drivers/pci/hotplug/shpchp_ctrl.c
> index 5849927..6efc2ec 100644
> --- a/drivers/pci/hotplug/shpchp_ctrl.c
> +++ b/drivers/pci/hotplug/shpchp_ctrl.c
> @@ -282,8 +282,8 @@ static int board_added(struct slot *p_slot)
> return WRONG_BUS_FREQUENCY;
> }
>
> - bsp = ctrl->pci_dev->bus->cur_bus_speed;
> - msp = ctrl->pci_dev->bus->max_bus_speed;
> + bsp = ctrl->pci_dev->subordinate->cur_bus_speed;
> + msp = ctrl->pci_dev->subordinate->max_bus_speed;
>
> /* Check if there are other slots or devices on the same bus */
> if (!list_empty(&ctrl->pci_dev->subordinate->devices))



\
 
 \ /
  Last update: 2014-05-04 16:21    [W:0.228 / U:0.188 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site