lkml.org 
[lkml]   [2014]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 4/7] of: configure the platform device dma parameters
On Thursday 29 May 2014 10:01 AM, Linus Walleij wrote:
> On Wed, May 28, 2014 at 4:04 PM, Santosh Shilimkar
> <santosh.shilimkar@ti.com> wrote:
>> On Wednesday 28 May 2014 09:32 AM, Linus Walleij wrote:
>
>>>> I suspect what you want is
>>>>
>>>> dma-ranges = <0x80000000 0 0x80000000>;
>>>>
>>>> to translate dma_addr_t 0x80000000-0xffffffff to phys_addr_t 0x0-0x7fffffff
>>>> rather than phys_addr_t 0x800000000-0x87fffffff.
>>>
>> Interesting. Where does the ROM address space resides on integrator then considering
>> address 0 is used for DMA.
>
> The ROM is at physical address 0x20000000, don't ask me
> why :-)
>
> The RAM is typically at 0x00000000-0x0fffffff, on up to four parallell
> tiles, i.e. up to four completely independent CPUs are booted off the
> same ROM and using a set of shared peripherals.
>
The reason I asked the question because most of the ARM SOC I came across
aren't using the RAM phys address 0 and thought was because of boot architecture
with ROM occupying that address with reset vector starting at address 0.

That was one of the main reason we had description on max_*pfn on ARM w.r.t
to other acrhes.

Will corner ARM guys to understand bit more about it in some conference ;-)

Thanks for clarification.

Regards,
Santosh


\
 
 \ /
  Last update: 2014-05-29 17:21    [W:0.094 / U:0.156 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site