Messages in this thread Patch in this message | | | From | Daniel Thompson <> | Subject | [RESEND PATCH v5 4/5] arm: Seperate DEBUG_UART_PHYS from DEBUG_LL on EP93XX | Date | Fri, 23 May 2014 16:10:18 +0100 |
| |
On EP93XX uncompress.h uses CONFIG_DEBUG_UART_PHYS instead of a hard coded serial port. This means the build breaks when DEBUG_LL (and DEBUG_LL_UART_PL01X) is not enabled.
This is fixed by adding a new dependancy.
Signed-off-by: Daniel Thompson <daniel.thompson@linaro.org> --- arch/arm/Kconfig.debug | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug index 4c8d7db..468cb3b 100644 --- a/arch/arm/Kconfig.debug +++ b/arch/arm/Kconfig.debug @@ -1069,7 +1069,8 @@ config DEBUG_UART_PHYS default 0xfffff700 if ARCH_IOP33X depends on DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \ DEBUG_LL_UART_EFM32 || \ - DEBUG_UART_8250 || DEBUG_UART_PL01X + DEBUG_UART_8250 || DEBUG_UART_PL01X || \ + ARCH_EP93XX config DEBUG_UART_VIRT hex "Virtual base address of debug UART" -- 1.9.0
| |