Messages in this thread | | | Subject | Re: [PATCH v2 2/3] drm/panel: add support for EDT panels | From | Philipp Zabel <> | Date | Thu, 15 May 2014 11:30:29 +0200 |
| |
Am Donnerstag, den 15.05.2014, 11:08 +0200 schrieb Thierry Reding: > On Thu, May 15, 2014 at 10:27:29AM +0200, Philipp Zabel wrote: > > Am Donnerstag, den 15.05.2014, 09:51 +0200 schrieb Thierry Reding: > > > On Wed, May 14, 2014 at 11:45:57PM +0200, stefan@agner.ch wrote: > > > > From: Stefan Agner <stefan@agner.ch> > > > > > > > > This panels are sold by Toradex for Colibri T20/T30 and Apalis T30 > > > > evaluation kits. > > > > > > > > Signed-off-by: Stefan Agner <stefan@agner.ch> > > > > > > Panel patches should go to the dri-devel mailing list as well. > > > > > > Also a patch was posted only yesterday for a panel that seems to be the > > > exact same one as this, even though the name differs minimally, see: > > > > > > https://patchwork.kernel.org/patch/4175251/ > > > > > > Adding Philipp on Cc so you guys can work together whether this is > > > indeed the same panel. The only differences seem to be in the vertical > > > front and back porches, but I suspect that either settings will work on > > > both Tegra and i.MX. > > > > The ETM0700G0DH6 Datasheet lists 2 lines as the typical vsync pulse > > width, 525 lines as the vertical period, and 35 lines as the vsync -de > > time, which is vsync len + back porch. > > So vertical timings 480 + 10 + 2 + 33 = 525 should be valid for the > > ET0700G0DH6 panel: > > Shouldn't that work with 480 + 8 + 2 + 35 too? It seems to me that it > should still be safe for that panel. Similarily I'd expect your timings > to work on the ET070080DH6. > > Irrespective of that they both seem to have different capabilities so > two compatible values should be fine. However for the purpose of the > simple panel driver they could be made to share the same timings if it > works for both panels and devices.
Yes. As I understand, the 480 + 10 + 2 + 33 timing should be correct for both panels.
> As for the touch panel on the ETM0700G0DH6, do you happen to know how > that's usually connected? I suspect it needs external hardware to > capture the YU, XL, YD and XR pins and turn that into raw coordinates > and pen down interrupts.
The ETM0700G0DH6 has a capacitive touch screen with an EDT-FT5406 controller connected via I2C, at least on the panels that I have seen.
regards Philipp
| |