lkml.org 
[lkml]   [2014]   [May]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] ARM: dts: am335x-bone-common: Add i2c2 definition
* Robert Nelson <robertcnelson@gmail.com> [140512 13:00]:
> >>
> >> + i2c2_pins: pinmux_i2c2_pins {
> >> + pinctrl-single,pins = <
> >> + 0x178 (PIN_INPUT_PULLUP | MUX_MODE3) /* uart1_ctsn.i2c2_sda */
> >> + 0x17c (PIN_INPUT_PULLUP | MUX_MODE3) /* uart1_rtsn.i2c2_scl */
> >> + >;
> >> + };
> >> +
> >> uart0_pins: pinmux_uart0_pins {
> >> pinctrl-single,pins = <
> >> 0x170 (PIN_INPUT_PULLUP | MUX_MODE0) /* uart0_rxd.uart0_rxd */
> >>
> >> @@ -222,6 +229,15 @@
> >>
> >> };
> >>
> >> +
> >> +&i2c2 {
> >> + pinctrl-names = "default";
> >> + pinctrl-0 = <&i2c2_pins>;
> >> +
> >> + status = "okay";
> >> + clock-frequency = <100000>;
> >> +};
> >> +
> >
> > If these pins are not used for i2c2 on some capes, this device
> > should be set to status = "disabled" state by default. Then
> > u-boot could re-enable it on the boards that have i2c2 in use.
>
> To-date, this is the i2c bus that all capes have placed an at24 eeprom
> for cape identification.

And how many capes actually implement the eeprom cape identification
out of the available capes? :)

Tony


\
 
 \ /
  Last update: 2014-05-12 23:01    [W:3.188 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site