lkml.org 
[lkml]   [2014]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 4/4] ARM: tegra: fix Venice2 VQMMC regulators
Date
Hi Stephen,

On Tue, Apr 15 2014, Stephen Warren wrote:
> Is there documentation re: what vmmc-supply and vqmmc-supply actually
> refer to? I looked a long while ago and couldn't find any, and didn't
> get an answer when I asked.
>
> Neither
> Documentation/devicetree/bindings/mmc/{mmc.txt,nvidia,tegra20-sdhci.txt}
> seem to say:-(

MMC cards use the same voltage for the VDD pin on the card and to pull
up the signal lines. UHS SDHCI switches to using 1.8V vqmmc (signaling
voltage) and 3.3V vmmc (card supply voltage).

So the idea is to supply a vqmmc-supply if your board supports
ultra-high-speed modes on an SD 3.0 host, and a vmmc-supply if your
card power is controlled by a regulator. I agree that this ought to
be in the bindings somewhere.

Thanks,

- Chris.
--
Chris Ball <http://printf.net/>


\
 
 \ /
  Last update: 2014-04-15 22:01    [W:0.081 / U:2.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site