Messages in this thread | | | From | Kevin Hilman <> | Subject | Re: [PATCH] ARM: qcom: Enable basic support for Qualcomm platforms in multi_v7_defconfig | Date | Fri, 28 Feb 2014 08:47:21 -0800 |
| |
Hi Kumar,
Kevin Hilman <khilman@linaro.org> writes:
> Kumar Gala <galak@codeaurora.org> writes: > >> Enable support for the MSM8x60, MSM8960, and MSM8974 SoCs, clocks and >> serial console as part of the standard multi_v7_defconfig. >> >> Signed-off-by: Kumar Gala <galak@codeaurora.org> >> --- >> >> I leave this to the arm-soc guys to apply because of possible conflicts >> with other updates to multi_v7_defconfig. > > Seem to be a handful of !qcom changes here, probably resulting from a > run of 'make savedefconfig' without all the new changes in. > > I've thinned this out to only the qcom changes and applied the following > to next/boards. I think it's better to do any 'make savedefconfig' > cleanups as a separate, cleanup-only patch as needed.
Bisecting a new boot failure on u8500/snowball came down to this patch. Simply disabling CONFIG_ARCH_QCOM in mutli_v7_defconfig gets the u8500/snowball booting again, so it looks like there may still be some qcom specifics that are being run on non-qcom platforms with a multi-platform config.
Could you audit for initcalls/drivers being initialized on non-qcom SoCs?
Thanks,
Kevin
| |