lkml.org 
[lkml]   [2014]   [Feb]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: put_page on transparent huge page leaks?
On Fri, Feb 21, 2014 at 11:23:39AM -0600, Jay Cornwall wrote:
> Hi,
>
> I'm tracking a possible memory leak in iommu/amd. The driver uses this logic
> to fault a page in response to a PRI from a device:
>
> npages = get_user_pages(fault->state->task, fault->state->mm,
> fault->address, 1, write, 0, &page, NULL);
>
> if (npages == 1)
> put_page(page);
> else
> ...
>
> This works correctly when get_user_pages returns a 4KB page. When
> transparent huge pages are enabled any 2MB page returned by this call
> appears to leak on process exit. The non-cached memory usage stays elevated
> by the set of faulted 2MB pages. This behavior is not observed when the
> exception handler demand faults 2MB pages.
>
> I notice there is a difference in reference count between the 4KB/2MB paths.
>
> get_user_pages (4KB): page_count()=3, page_mapcount()=1
> put_page (4KB): page_count()=2, page_mapcount()=1
>
> get_user_pages (2MB): page_count()=3, page_mapcount()=1
> put_page (2MB): page_count()=3, page_mapcount()=0
>
> I'm concerned that the driver appears to be holding a reference count after
> put_page(). Am I interpreting this observation correctly?

Could you show output of dump_page() on 2M pages for both points?

My guess is that your page is PageTail(). Refcounting for tail pages is
different: on get_page() we increase *->_mapcount* of tail and increase
->_count of relevant head page. ->_count of tail pages should always be
zero, but it's 3 in your case which is odd.

BTW, I don't see where you take mmap_sem in drivers/iommu/amd_iommu_v2.c,
which is required for gup. Do I miss something?

--
Kirill A. Shutemov


\
 
 \ /
  Last update: 2014-02-22 04:21    [W:0.066 / U:2.364 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site