lkml.org 
[lkml]   [2014]   [Feb]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC v2 2/4] net: enables interface option to skip IP
On 20/02/14 20:39, Luis R. Rodriguez wrote:
> On Wed, Feb 19, 2014 at 11:13 AM, Zoltan Kiss <zoltan.kiss@citrix.com> wrote:
>> On 19/02/14 17:20, Luis R. Rodriguez wrote:
>>>>> On 19/02/14 17:20, Luis R. Rodriguez also wrote:
>>>>> Zoltan has noted though some use cases of IPv4 or IPv6 addresses on
>>>>> backends though <...>
>>>
>>> As discussed in the other threads though there *is* some use cases
>>> of assigning IPv4 or IPv6 addresses to the backend interfaces though:
>>> routing them (although its unclear to me if iptables can be used
>>> instead, Zoltan?).
>>
>> Not with OVS, it steals the packet before netfilter hooks.
>
> Got it, thanks! Can't the route be added using a front-end IP address
> instead on the host though ? I just tried that on a Xen system and it
> seems to work. Perhaps I'm not understand the exact topology on the
> routing case. So in my case I have the backend without any IPv4 or
> IPv6 interfaces, the guest has IPv4, IPv6 addresses and even a TUN for
> VPN and I can create routes on the host to the front end by not using
> the backend device name but instead using the front-end target IP.
Check this how current Xen scripts does routed networking:

http://wiki.xen.org/wiki/Xen_Networking#Associating_routes_with_virtual_devices

Note, there are no bridges involved here! As the above page says, the
backend has to have IP address, maybe it's not true anymore. I'm not too
familiar with this setup too, I've used it only once.

Zoli



\
 
 \ /
  Last update: 2014-02-21 15:01    [W:0.180 / U:0.660 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site