lkml.org 
[lkml]   [2014]   [Feb]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 07/10] spi: sh-msiof: Add support for R-Car H2 and M2
From
On Thu, Feb 20, 2014 at 4:41 PM, Magnus Damm <magnus.damm@gmail.com> wrote:
> On thing stuck out a bit with the bindings. I can see that you specify
> both fifo size and use the SoC suffix for the r8a7790 and r8a7791
> bindings. Isn't that a bit of redundant information there, if we know
> that the SoC is r8a7790 or r8a7791 then can't we simply put that
> information in r8a779x_data above and perhaps keep the binding
> simpler? Perhaps same thing applies to other properties as well?

"renesas,tx-fifo-size" and "renesas,rx-fifo-size" are part of the existing
bindings, so I'm a bit reluctant to change these.
Hmm, since the original bindings didn't specify the default values,
I could make them chip-specific, though.

The only other property is "num-cs", which can have any value if you
start using the generic "cs-gpios".

Gr{oetje,eeting}s,

Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds


\
 
 \ /
  Last update: 2014-02-20 17:41    [W:0.081 / U:2.980 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site