lkml.org 
[lkml]   [2014]   [Feb]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] serial: pl011: Move uart_register_driver call to device probe
On Thu, Feb 13, 2014 at 10:27:01AM -0800, Greg KH wrote:
> On Thu, Feb 13, 2014 at 06:15:59PM +0000, Russell King - ARM Linux wrote:
> > On Thu, Feb 13, 2014 at 10:12:16AM -0800, Greg KH wrote:
> > > On Mon, Jan 20, 2014 at 10:04:15AM +0000, Russell King - ARM Linux wrote:
> > > > On Mon, Jan 20, 2014 at 02:32:35PM +0530, Tushar Behera wrote:
> > > > > uart_register_driver call binds the driver to a specific device
> > > > > node through tty_register_driver call. This should typically happen
> > > > > during device probe call.
> > > > >
> > > > > In a multiplatform scenario, it is possible that multiple serial
> > > > > drivers are part of the kernel. Currently the driver registration fails
> > > > > if multiple serial drivers with same default major/minor numbers are
> > > > > included in the kernel.
> > > > >
> > > > > A typical case is observed with amba-pl011 and samsung-uart drivers.
> > > >
> > > > NAK. There should not be any other driver using amba-pl011's device numbers.
> > >
> > > I agree, but there is. And because of that, moving the registration to
> > > the probe call fixes the issue with building a kernel with all of the
> > > drivers built into them, so I'm going to take both of these patches, as
> > > it does solve that problem, while still allowing the device number
> > > collision to happen.
> >
> > So what happens when two _devices_ are probed by this driver at the same
> > time?
>
> The bus that the driver is on will not allow that to happen, I thought
> we went through this before...
>
> And yes, devices on different busses could cause problems, but is that
> the case here for these devices? At first glance, I don't think that
> can happen for these drivers.

We went through this before, and I stated the paths, and no one disagreed
with that.

It /is/ racy.

--
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up. Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".


\
 
 \ /
  Last update: 2014-02-13 21:41    [W:0.174 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site