lkml.org 
[lkml]   [2014]   [Dec]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: using DMA-API on ARM
On Fri, Dec 05, 2014 at 01:43:01PM +0100, Arend van Spriel wrote:
> Ok. You already had a peek in our code checking the memory barriers, which
> does not have the dma_sync_single_for_cpu() "workaround" yet. So here some
> more background. The problem is in DMA_FROM_DEVICE direction. Because of the
> possible reordering issue we first tried using rmb() in the retry loop but
> that did not solve it. Another experiment was to ignore the failed ring
> descriptor entry and proceed. So we get interrupt from device and access the
> ring descriptor entry. This should contain expected value X, however we get
> X-1 back. When proceeding everything works find until hitting the same ring
> descriptor entry again reading X-1 when X+1 would be valid. This lead us to
> the assumption that somehow this entry ended up in cache lines. The issue
> goes away using the dma_sync_single_for_cpu() with DMA_FROM_DEVICE in
> direction parameter.

Can you give some further detail - I think it would help understanding
if you could give:

- the initial numerical state of the descriptor (presumably setup by
msgbuf.c calling brcmf_commonring_reserve_for_write(), and then
writing the contents into the ring buffer, followed by
brcmf_commonring_write_complete().

- time passes, the hardware processes the entry

- the numerical state of the descriptor (which is in error) which you
read back

- the expected numerical state of the descriptor

> So is there any function interface to verify cache status.

There isn't, but if you dump the virtual address, and you have debugfs
enabled, along with CONFIG_ARM_PTDUMP, you should be able to find the
mapping in /sys/kernel/debug/kernel_page_tables, which will tell you
the attributes that it's mapped using.

What it won't tell you is whether there's an alias of the mapping with
differing attributes. If you use dma_to_pfn() to convert the DMA handle
into a PFN, we can use that to see whether there could be another mapping
from the kernel page table dump (by checking whether the PFN would be a
lowmem PFN, and therefore whether it's already mapped at it's lowmem
address.)

If you'd like to mail me (in addition to the ring contents above):

- the kernel_page_tables dump
- virtual address of the ring buffer
- dma_to_pfn() converted DMA handle of the ring buffer
- PHYS_PFN_OFFSET for your platform

then I can see whether there is.

--
FTTC broadband for 0.8mile line: currently at 9.5Mbps down 400kbps up
according to speedtest.net.


\
 
 \ /
  Last update: 2014-12-05 14:21    [W:2.249 / U:0.216 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site