lkml.org 
[lkml]   [2014]   [Dec]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH V3] MIPS: BCM47XX: Move NVRAM driver to the drivers/soc/
From
On 4 December 2014 at 07:43, Paul Walmsley <paul@pwsan.com> wrote:
> Hello Rafał,
>
> On Fri, 28 Nov 2014, Paul Walmsley wrote:
>
>> On Thu, 27 Nov 2014, Rafał Miłecki wrote:
>>
>> > I'm pretty sure you look at some old version of arch/bcm47xx/nvram.c.
>> > I wouldn't dare to move such a MIPS-focused driver to some common
>> > place ;)
>> >
>> > Please check for the version of nvram.c in Ralf's upstream-sfr tree. I
>> > think you'll like it much more. Hopefully you will even consider it
>> > ready for moving to the drivers/firmware/ or whatever :)
>>
>> OK I will take a look at this, and will either send comments, or will
>> send a Reviewed-By:.
>
> I had the chance to take a brief look at this file, and you are right: I
> like your newer version better than the older one :-)
>
> It is too bad that it seems this flash area has to be accessed very early
> in boot. That certainly makes it more difficult to write something
> particularly elegant. It is also a pity that it is unknown how to verify
> that the flash MMIO window has been configured before reading from these
> areas of the address space. But under the circumstances, calling
> bcm47xx_nvram_init_from_mem() with the appropriate addresses from the bus
> code during early init, as you did, seems rather reasonable. I also like
> the code that you added to read the flash data from MTD later in boot.
>
> Here are a few very minor comments that you are welcome to take or leave
> as you wish.

Thanks for your comments! I'll address them before (trying) moving
driver to the drivers/firmware/. Appreciate your review.


\
 
 \ /
  Last update: 2014-12-04 09:01    [W:0.062 / U:0.176 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site