Messages in this thread | | | Date | Thu, 25 Dec 2014 10:13:57 +0800 | From | Peter Chen <> | Subject | Re: [PATCH 1/3] usb: chipidea: Add identification registers access APIs |
| |
On Wed, Dec 24, 2014 at 09:45:31PM +0530, Sanchayan Maity wrote: > On 12/24/2014 09:30 PM, Stefan Agner wrote: > > On 2014-12-19 10:55, Sanchayan Maity wrote: > >> Using hw_write_id_reg and hw_read_id_reg to write and read > >> identification registers contents. This can be used to get > >> controller information, change some system configurations > >> and so on. > > > > Checkpatch is complaining about DOS line endings and some trailing > > whitespace. This applies to all three patches. > > Hmm... that's surprising. I did run checkpatch at my end before sending. > I do not have the original patchset on my laptop which I have right now > but downloading diffs back from lkml and running checkpatch on them back, > only gives me signed off errors as it should. > > I will resend if somehow errors crept in with my earlier patches. > > -Sanchayan >
Hi Sanchayan,
I will take care the first two, you are the third if there is any comments, thanks.
--
Best Regards, Peter Chen
| |