lkml.org 
[lkml]   [2014]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V5 14/23] MIPS: BMIPS: Document the firmware->kernel DTB interface
Date
Add a new section covering the Generic BMIPS machine type.

Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
---
Documentation/devicetree/booting-without-of.txt | 28 +++++++++++++++++++++++++
1 file changed, 28 insertions(+)

diff --git a/Documentation/devicetree/booting-without-of.txt b/Documentation/devicetree/booting-without-of.txt
index 7768518..e49e423 100644
--- a/Documentation/devicetree/booting-without-of.txt
+++ b/Documentation/devicetree/booting-without-of.txt
@@ -15,6 +15,7 @@ Table of Contents
1) Entry point for arch/arm
2) Entry point for arch/powerpc
3) Entry point for arch/x86
+ 4) Entry point for arch/mips/bmips

II - The DT block format
1) Header
@@ -288,6 +289,33 @@ it with special cases.
or initrd address. It simply holds information which can not be retrieved
otherwise like interrupt routing or a list of devices behind an I2C bus.

+4) Entry point for arch/mips/bmips
+----------------------------------
+
+ Some bootloaders only support a single entry point, at the start of the
+ kernel image. Other bootloaders will jump to the ELF start address.
+ Both schemes are supported; CONFIG_BOOT_RAW=y and CONFIG_NO_EXCEPT_FILL=y,
+ so the first instruction immediately jumps to kernel_entry().
+
+ Similar to the arch/arm case (b), a DT-aware bootloader is expected to
+ set up the following registers:
+
+ a0 : 0
+
+ a1 : 0xffffffff
+
+ a2 : Physical pointer to the device tree block (defined in chapter
+ II) in RAM. The device tree can be located anywhere in the first
+ 512MB of the physical address space (0x00000000 - 0x1fffffff),
+ aligned on a 64 bit boundary.
+
+ Legacy bootloaders do not use this convention, and they do not pass in a
+ DT block. In this case, Linux will look for a builtin DTB, selected via
+ CONFIG_DT_*.
+
+ This convention is defined for 32-bit systems only, as there are not
+ currently any 64-bit BMIPS implementations.
+
II - The DT block format
========================

--
2.1.1


\
 
 \ /
  Last update: 2014-12-12 23:41    [W:0.080 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site