Messages in this thread Patch in this message | | | From | Chris Zhong <> | Subject | [PATCH v2 1/2] mfd: dt-bindings: add the description about dvs gpio for rk808 | Date | Thu, 11 Dec 2014 11:16:41 +0800 |
| |
add the description about dvs1, dvs2, dvsok, and add the example.
Signed-off-by: Chris Zhong <zyw@rock-chips.com>
---
Changes in v2: - increase description about dvs pins
Documentation/devicetree/bindings/mfd/rk808.txt | 13 ++++++++++++- 1 file changed, 12 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/mfd/rk808.txt b/Documentation/devicetree/bindings/mfd/rk808.txt index 9e6e259..923cdca 100644 --- a/Documentation/devicetree/bindings/mfd/rk808.txt +++ b/Documentation/devicetree/bindings/mfd/rk808.txt @@ -24,6 +24,14 @@ Optional properties: - vcc10-supply: The input supply for LDO_REG6 - vcc11-supply: The input supply for LDO_REG8 - vcc12-supply: The input supply for SWITCH_REG2 +- dvs-gpios: buck1/2 can be controlled by gpio dvs, this is GPIO specifiers + for 2 host gpio's used for dvs. The format of the gpio specifier depends in + the gpio controller. If DVS GPIOs aren't present, voltage changes will happen + without being very quickly with no slow ramp time. +- dvsok-gpios: if we use dvs gpio to control buck1/2, this gpio will be pull + high, once RK808 completed the adjustment of voltage. If the DVSOK isn't + present, we'll just delay based on whatever is specified in the regulator + constraints. Regulators: All the regulators of RK808 to be instantiated shall be listed in a child node named 'regulators'. Each regulator is represented @@ -55,7 +63,10 @@ Example: interrupt-parent = <&gpio0>; interrupts = <4 IRQ_TYPE_LEVEL_LOW>; pinctrl-names = "default"; - pinctrl-0 = <&pmic_int>; + pinctrl-0 = <&pmic_int &dvs_ok &dvs_1 &dvs_2>; + dvsok-gpios = <&gpio7 9 GPIO_ACTIVE_HIGH>; + dvs-gpios = <&gpio7 11 GPIO_ACTIVE_HIGH>, + <&gpio7 15 GPIO_ACTIVE_HIGH>; reg = <0x1b>; rockchip,system-power-controller; wakeup-source; -- 1.9.1
| |