lkml.org 
[lkml]   [2014]   [Nov]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] clk: Propagate prepare and enable when reparenting orphans
On Wed, Nov 19, 2014 at 09:15:41PM -0800, Doug Anderson wrote:
> Mike,
>
> On Wed, Nov 19, 2014 at 6:30 PM, Mike Turquette <mturquette@linaro.org> wrote:
> > Quoting Doug Anderson (2014-11-07 17:06:58)
> >> With the existing code, if you find a parent for an orhpan that has
> >> already been prepared / enabled, you won't enable the parent. That
> >> can cause later problems since the clock tree isn't in a consistent
> >> state. Fix by propagating the prepare and enable.
> >>
> >> NOTE: this does bring up the question about whether the enable of the
> >> orphan actually made sense. If the orphan's parent wasn't enabled by
> >> default (by the bootloader or the default state of the hardware) then
> >> the original enable of the orphan probably didn't do what the caller
> >> though it would. Some users of the orphan might have preferred an
> >> EPROBE_DEFER be returned until we had a full path to a root clock.
> >> This patch doesn't address those concerns and really just syncs up the
> >> state.
> >
> > -ECANOFWORMS
> >
> > I'm thinking about this patch but I haven't quite made up my mind. It is
> > reasonable, but also some nice kind of error might be preferable when
> > preparing/enabling an orphaned clock.
> >
> > Under what conditions might a clock be orphaned? An obvious example is
> > just bad luck during the thundering herd of clock registrations from a
> > driver. In this case deferring the probe might be a good idea.
> >
> > However what about the case where a loadable module provides the parent
> > clock? It might be a long time before the orphan clocks gets picked up
> > from the orphanage. Is deferring probe the right thing here as well?
>
> I will defer to your wisdom here. I agree that these are the two
> primary solutions and I've picked one, but I have no idea which will
> be more of a PITA in the long run.
>
> Note: I'm not sure that anyone expects EPROBE_DEFER to be returned
> from a clk_enable() (do they?). It almost seems like the right answer
> is to fail to allow anyone to clk_get() any clock that doesn't have a
> path to root.

EPROBE_DEFER only makes sense in driver's probe paths and so I would be
very against adding it to clk_enable() which is called from many places
in the kernel. If we decide to go with EPROBE_DEFER then returning it
from clk_get() seems like a much better choice since it is normally
called during probing.

Thanks.

--
Dmitry


\
 
 \ /
  Last update: 2014-11-20 09:21    [W:0.038 / U:0.448 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site