lkml.org 
[lkml]   [2014]   [Nov]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[alsa-devel][PATCH v2 2/2] ASoC: wm8960: LRCM operation should after software reset
Date
When shared_lrclk is set, LRCM will be enabled. But the following software
reset in wm8960_probe will reset it to the default state. So LRCM operation
should after software reset.

Signed-off-by: Zidan Wang <b50113@freescale.com>
---
sound/soc/codecs/wm8960.c | 18 ++++++++----------
1 file changed, 8 insertions(+), 10 deletions(-)

diff --git a/sound/soc/codecs/wm8960.c b/sound/soc/codecs/wm8960.c
index e5d89a2..a7f60b7 100644
--- a/sound/soc/codecs/wm8960.c
+++ b/sound/soc/codecs/wm8960.c
@@ -976,6 +976,14 @@ static int wm8960_probe(struct snd_soc_codec *codec)
return ret;
}

+ if (pdata->shared_lrclk) {
+ ret = snd_soc_update_bits(codec, WM8960_ADDCTL2, 0x4, 0x4);
+ if (ret < 0) {
+ dev_err(codec->dev, "Failed to enable LRCM: %d\n", ret);
+ return ret;
+ }
+ }
+
wm8960->set_bias_level(codec, SND_SOC_BIAS_STANDBY);

/* Latch the update bits */
@@ -1059,16 +1067,6 @@ static int wm8960_i2c_probe(struct i2c_client *i2c,
else if (i2c->dev.of_node)
wm8960_set_pdata_from_of(i2c, &wm8960->pdata);

- if (pdata && pdata->shared_lrclk) {
- ret = regmap_update_bits(wm8960->regmap, WM8960_ADDCTL2,
- 0x4, 0x4);
- if (ret != 0) {
- dev_err(&i2c->dev, "Failed to enable LRCM: %d\n",
- ret);
- return ret;
- }
- }
-
i2c_set_clientdata(i2c, wm8960);

ret = snd_soc_register_codec(&i2c->dev,
--
1.9.1


\
 
 \ /
  Last update: 2014-11-20 10:21    [W:0.041 / U:0.236 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site