lkml.org 
[lkml]   [2014]   [Nov]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3] usb: dwc2: add bus suspend/resume for dwc2
From
Kever,

On Mon, Nov 10, 2014 at 5:09 AM, Kever Yang <kever.yang@rock-chips.com> wrote:
> Hcd controller needs bus_suspend/resume, dwc2 controller make
> root hub generate suspend/resume signal with hprt0 register
> when work in host mode.
> After the root hub enter suspend, we can make controller enter
> low power state with PCGCTL register.
>
> We also update the lx_state for hsotg state.
>
> This patch has tested on rk3288 with suspend/resume.
>
> Signed-off-by: Kever Yang <kever.yang@rock-chips.com>
> Acked-by: Paul Zimmerman <paulz@synopsys.com>
> ---
>
> Changes in v3:
> - remove CONFIG_PM macro for bus_suspend/resume
> - add PCGCTL operation for no device connect case
>
> Changes in v2:
> - update commit message
> - make dwc2 suspend/resume sourcecode work
>
> drivers/usb/dwc2/hcd.c | 88 +++++++++++++++++++++++++++++++++++++++++++-------
> 1 file changed, 77 insertions(+), 11 deletions(-)

I would certainly appreciate confirmation, but my inclination is to
NAK this change due to the fact that it regresses functionality. I
haven't done any serious review of it, but I've been testing it and it
appears to break hotplug.

Said another way, I did this:

1. Without this patch, I booted with a USB stick in. It was detected.
I unplugged it, waited 5 seconds, and then plugged it back in. The
USB stick was redetcted.

2. With this patch, I did the same thing. The USB not redected after
plugging it back in.

-Doug


\
 
 \ /
  Last update: 2014-11-13 00:41    [W:0.114 / U:0.400 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site