lkml.org 
[lkml]   [2014]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC Patch] gpio: add GPIO hogging mechanism
On Thu, Oct 30, 2014 at 1:42 AM, Pantelis Antoniou
<pantelis.antoniou@gmail.com> wrote:
> Hi Benoit,
>
>> On Oct 29, 2014, at 18:34 , Benoit Parrot <bparrot@ti.com> wrote:
>>
>> Pantelis,
>>
>> Thanks for the feedback.
>>
>> Pantelis Antoniou <pantelis.antoniou@gmail.com> wrote on Wed [2014-Oct-29 10:53:44 +0200]:
>>> Hi Benoit,
>>>
>>>> On Oct 21, 2014, at 23:09 , Benoit Parrot <bparrot@ti.com> wrote:
>>>>
>>>> Based on Boris Brezillion work this is a reworked patch
>>>> of his initial GPIO hogging mechanism.
>>>> This patch provides a way to initally configure specific GPIO
>>>> when the gpio controller is probe.
>>>>
>>>> The actual DT scanning to collect the GPIO specific data is performed
>>>> as part of the gpiochip_add().
>>>>
>>>> The purpose of this is to allows specific GPIOs to be configured
>>>> without any driver specific code.
>>>> This particularly usueful because board design are getting
>>>> increassingly complex and given SoC pins can now have upward
>>>> of 10 mux values a lot of connections are now dependent on
>>>> external IO muxes to switch various modes and combination.
>>>>
>>>> Specific drivers should not necessarily need to be aware of
>>>> what accounts to a specific board implementation. This board level
>>>> "description" should be best kept as part of the dts file.
>>>>
>>>
>>> This look like it’s going to the right direction. I have a few general
>>> comments at first.
>>>
>>> 1) It relies on dubious DT binding of having sub-nodes of the
>>> gpio device implicitly defining hogs.
>>
>> I think in this instance the nodes are explicitly defining hogs.
>> Please clarify. What would you like to see here?
>>>
>
> Any subnodes are implicitly taken as hog definitions. This is not right because
> gpio controllers might have subnodes that they use for another purpose.
>
>>> 2) There is no way for having hogs inserted dynamically as far as I can tell, and
>>> no way to remove a hog either.
>>
>> The original patch was allowing that but, Linus's review comment suggested this feature be
>> part of the gpio-controller's gpiochip_add() hook only.
>>
>
> If it’s not possible to remove a hog, then it’s no good for my use case in which
> the gpios get exported and then removed.

Why would you want to remove a GPIO hog at runtime, and what is the
point of having it set in the DT in that case?
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2014-10-30 01:41    [W:0.074 / U:2.216 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site