[lkml]   [2014]   [Oct]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH] mtd: cfi_cmdset_0001.c: fix resume for LH28F640BF chips
After '#echo mem > /sys/power/state' some devices can not be properly resumed
because apparently the MTD Partition Configuration Register has been reset
to default thus the rootfs cannot be mounted cleanly on resume.
An example of this can be found in the SA-1100 Developer's Manual at
where the second step of the Sleep Shutdown Sequence is described:
"An internal reset is applied to the SA-1100. All units are reset...".

As workaround we refresh the PCR value as done initially on chip setup.

This behavior and the fix are confirmed by our tests done on 2 different Zaurus
collie units with kernel 3.17.

Signed-off-by: Dmitry Eremin-Solenikov <>
Signed-off-by: Andrea Adami <>
drivers/mtd/chips/cfi_cmdset_0001.c | 2 ++
1 file changed, 2 insertions(+)

diff --git a/drivers/mtd/chips/cfi_cmdset_0001.c b/drivers/mtd/chips/cfi_cmdset_0001.c
index a7543ba..59e2355 100644
--- a/drivers/mtd/chips/cfi_cmdset_0001.c
+++ b/drivers/mtd/chips/cfi_cmdset_0001.c
@@ -2590,6 +2590,8 @@ static void cfi_intelext_resume(struct mtd_info *mtd)

/* Go to known state. Chip may have been power cycled */
if (chip->state == FL_PM_SUSPENDED) {
+ /* Refresh LH28F640BF Partition Config. Register */
+ fixup_LH28F640BF(mtd);
map_write(map, CMD(0xFF), cfi->chips[i].start);
chip->oldstate = chip->state = FL_READY;

 \ /
  Last update: 2014-10-23 02:01    [W:0.083 / U:2.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site