| Date | Tue, 21 Oct 2014 22:52:05 +0200 | From | Andreas Färber <> | Subject | Re: [PATCH v2 00/11] ARM: dts: zynq: Prepare Parallella |
| |
Hi Olof and Sören,
Am 18.10.2014 um 06:28 schrieb Olof Johansson: > On Thu, Jul 24, 2014 at 4:00 PM, Andreas Färber <afaerber@suse.de> wrote: >> Hello, >> >> This patch series adds an initial device tree for the Parallella board. >> UART, SD card, Ethernet are enabled. >> Not yet enabled are HDMI, QSPI flash and 2x USB. > > Andreas (Olofsson) kindly sent me a board, and I added it to the boot > farm today, it'll be included in boot reports from here on.
Good to hear.
> I did a test run with yesterday's -next It looks like networking isn't > working there at the moment, clock related. Same happens with 3.17 and > latest mainline, config multi_v7_defconfig: > > [WARN] [ 7.943648] macb e000b000.ethernet eth0: unable to generate > target frequency: 125000000 Hz > [WARN] [ 10.948681] macb e000b000.ethernet eth0: unable to generate > target frequency: 125000000 Hz
I am unable to reproduce this in my setup - at Linus' tip c2661b806092d8ea2dccb7b02b65776555e0ee47 (v3.18-rc1-68-gc2661b8), make oldconfig'ing my /proc/config.gz.
Sören, in light of your explanations, should I be expecting problems with 1GbE or with 100MbE? My board is connected to a 1GbE switch.
Regards, Andreas
-- SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg, Germany GF: Jeff Hawn, Jennifer Guild, Felix Imendörffer; HRB 16746 AG Nürnberg
[unhandled content-type:application/pgp-signature] |