lkml.org 
[lkml]   [2014]   [Oct]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC/PATCH 1/5] mtd: ubi: Read disturb infrastructure
Am 02.10.2014 15:42, schrieb Tanya Brokhman:
> On 10/2/2014 4:24 PM, Richard Weinberger wrote:
>> Am 02.10.2014 14:50, schrieb Tanya Brokhman:
>>>> Consider the case where you have a board with a fastmap enabled bootloader and a Linux OS.
>>>> The bootloader does a fastmap attach and boots the kernel from UBI and the kernel it self has the rootfs
>>>> on UBI too. If you install a new kernel with your changes applied it will write the fastmap in a different
>>>> format and the bootloader will fail badly. In worst case the board bricks, in best case the bootloader can fall back
>>>> to scanning mode but it will be slow and the customer unhappy.
>>>>
>>>
>>> Ok, I understand the problem now. I wanted to discuss a possible solution before implementing it:
>>> We have a "fastmap version" in fm_sb. At the moment UBI_FM_FMT_VERSION = 1 and any other is not supported. We can use that; Add another fm version (UBI_FM_FMT_VERSION_RD = 2) and
>>> then decide according to it. Meaning, if during attach process we find fm superblock we check it's version, if it's != UBI_FM_FMT_VERSION_RD, we fall back to full scan. The next
>>> fastmap will be written with the new layout (and new version number) so second boot will attach from fastmap without any issues.
>>
>> Yes, if we change the fastmap on-disk layout we need to change UBI_FM_FMT_VERSION.
>> Then other fastmap implementations will notice the change and can hopefully recover.
>> Implementations which do not evaluate UBI_FM_FMT_VERSION deserve breaking. ;-)
>
> good. will work on the fix and upload a new set when ready&tested.
>
>>
>> That said, I'll not block a layout change but we have to be sure that it is *really* needed.
>
> In order to support read-disturb, I think its really needed. There is no other way to save read counter per PEB but in fastmap.

The question is, do we really need all this values on-flash?
You could create a simple sysfs or ioctl() interface to pass these values to userspace.
Then you can hack up an userspace daemon which monitors the counters and triggers a check if needed.
The daemon can also store the counter into a flat file. If think you don't need exact counters,
there it does not hurt if the daemon does not store the most current values at a power cut.

Thanks,
//richard


\
 
 \ /
  Last update: 2014-10-02 16:41    [W:0.543 / U:0.248 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site