lkml.org 
[lkml]   [2014]   [Oct]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2] mmc: dw_mmc: Reset DMA before enabling IDMAC
On Fri, Oct 17, 2014 at 1:26 AM, Jaehoon Chung <jh80.chung@samsung.com> wrote:
> Hi, Sonny.
>
> On 10/17/2014 01:58 AM, Sonny Rao wrote:
>> We've already got a reset of DMA after it's done. Add one before we
>> start DMA too. This fixes a data corruption on Rockchip SoCs which
>> will get bad data when doing a DMA transfer after doing a PIO transfer.
>>
>> We tested this on an Exynos 5800 with HS200 and didn't notice any
>> difference in sequential read throughput.
>
> Didn't affect the write throughput?

Write is usually much slower than read, but I went ahead and re-tested
and saw no difference on writes.

> I tested this on exynos3/4 with DDR50 and HS200.
>
> Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
> Tested-by: Jaehoon Chung <jh80.chung@samsung.com>
>
>>
>> Signed-off-by: Sonny Rao <sonnyrao@chromium.org>
>> Signed-off-by: Doug Anderson <dianders@chromium.org>
>> Tested-by: Doug Anderson <dianders@chromium.org>
>> ---
>> drivers/mmc/host/dw_mmc.c | 5 +++++
>> 1 file changed, 5 insertions(+)
>>
>> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
>> index 69f0cc6..ca67f69 100644
>> --- a/drivers/mmc/host/dw_mmc.c
>> +++ b/drivers/mmc/host/dw_mmc.c
>> @@ -83,6 +83,7 @@ struct idmac_desc {
>> #endif /* CONFIG_MMC_DW_IDMAC */
>>
>> static bool dw_mci_reset(struct dw_mci *host);
>> +static bool dw_mci_ctrl_reset(struct dw_mci *host, u32 reset);
>>
>> #if defined(CONFIG_DEBUG_FS)
>> static int dw_mci_req_show(struct seq_file *s, void *v)
>> @@ -448,6 +449,10 @@ static void dw_mci_idmac_start_dma(struct dw_mci *host, unsigned int sg_len)
>>
>> dw_mci_translate_sglist(host, host->data, sg_len);
>>
>> + /* Make sure to reset DMA in case we did PIO before this */
>> + dw_mci_ctrl_reset(host, SDMMC_CTRL_DMA_RESET);
>> + dw_mci_idmac_reset(host);
>> +
>> /* Select IDMAC interface */
>> temp = mci_readl(host, CTRL);
>> temp |= SDMMC_CTRL_USE_IDMAC;
>>
>


\
 
 \ /
  Last update: 2014-10-18 23:21    [W:0.080 / U:0.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site