lkml.org 
[lkml]   [2014]   [Jan]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/2] serial: samsung: Move uart_register_driver call to device probe
On Mon, Jan 20, 2014 at 03:11:41PM -0800, Greg KH wrote:
> On Mon, Jan 20, 2014 at 09:32:06PM +0000, Russell King - ARM Linux wrote:
> > On Mon, Jan 20, 2014 at 01:16:01PM -0800, Greg KH wrote:
> > > On Mon, Jan 20, 2014 at 10:05:30AM +0000, Russell King - ARM Linux wrote:
> > > > On Mon, Jan 20, 2014 at 02:32:34PM +0530, Tushar Behera wrote:
> > > > > uart_register_driver call binds the driver to a specific device
> > > > > node through tty_register_driver call. This should typically happen
> > > > > during device probe call.
> > > > >
> > > > > In a multiplatform scenario, it is possible that multiple serial
> > > > > drivers are part of the kernel. Currently the driver registration fails
> > > > > if multiple serial drivers with same default major/minor numbers are
> > > > > included in the kernel.
> > > > >
> > > > > A typical case is observed with amba-pl011 and samsung-uart drivers.
> > > >
> > > > The samsung-uart driver is at fault here - the major/minor numbers were
> > > > officially registered to amba-pl011. Samsung needs to be fixed properly.
> > >
> > > I agree, the Samsung driver is "broken" here, but that's no reason why
> > > these two drivers can't register with the tty layer _after_ the hardware
> > > is detected, and not before.
> > >
> > > That saves resources on systems that build the drivers in, yet do not
> > > have the hardware present, which is always a good thing.
> >
> > Great, so what you're saying is that we need to wait until the first
> > device calls into the probe function. What about removal... how does
> > a driver know when it's last device has been removed to de-register
> > that?
>
> The "bus" that the device is on handles that, right?
>
> > I guess it needs the driver model to provide some way to know when a
> > driver is completely unbound - but isn't that racy?
>
> How is it racy? That's how the driver model works...

Think about what happens when the last device unregisters, but a new
device comes along and is probed.

I don't believe the driver model has any locking to prevent a drivers
->probe function running concurrently with it's ->remove function for
two (or more) devices.

The locking against this is done on a per-device basis, not a per-driver
basis.

--
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up. Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".


\
 
 \ /
  Last update: 2014-01-21 00:41    [W:0.089 / U:0.924 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site