lkml.org 
[lkml]   [2013]   [Sep]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH 5/6] extcon-gpio: Describe devicetree bindings
On Thu, Sep 19, 2013 at 05:42:45PM +0100, Mark Brown wrote:
> On Wed, Sep 18, 2013 at 04:38:28PM +0100, Mark Rutland wrote:
> > On Mon, Sep 16, 2013 at 04:19:53PM +0100, Guenter Roeck wrote:
>
> > > I think what you are saying is that describing a generic connector via
> > > devicetree is not acceptable, even though it _does_ describe hardware.
> > > I would have to describe a specific connector for a specific hardware
> > > instead, which in turn would need its own driver. Is that correct ?
>
> > Regardless of how the connector is described, the block of hardware it
> > connects to will have to be described, and some description of the
> > connector will be necessary (either in the node for the block, or by
> > phandle to a node for the connector). I agree that having a combined IP
> > block + connector driver for each permutation is not good.
>
> Many of the things described only have passive components attached, or
> things that otherwise don't need drivers - things like power inputs or
> headphone connectors, they're mainly providing information to allow
> userspace to behave differently (eg, display a charging indicator in the
> UI). It's not 100% true but by and by large if detection is being done
> using a GPIO it's probably something like that.

Correct. However, gpio based 'detect' pins typically need debounce support
which is not directly available through the gpio userspace API. I tried to add
that earlier, but was told to use extcon instead as it provides the necessary
infrastructure. Now it almost looks like I can not use it either because the
required devicetree bindings may be considered unacceptable.

Guenter


\
 
 \ /
  Last update: 2013-09-19 20:41    [W:1.644 / U:0.480 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site