Messages in this thread | ![/](/images/icornerl.gif) | | Date | Wed, 28 Aug 2013 15:48:39 +0200 | Subject | Re: [PATCH] pinctrl: at91: add support for OUTPUT config | From | Linus Walleij <> |
| |
On Wed, Aug 28, 2013 at 3:46 PM, Linus Walleij <linus.walleij@linaro.org> wrote: > On Tue, Aug 27, 2013 at 4:51 PM, Boris BREZILLON > <b.brezillon@overkiz.com> wrote: > >> Add support for pin output control through the pinctrl config: >> - support enabling/disabling output on a given pin >> - support output level setting (high or low) >> >> Signed-off-by: Boris BREZILLON <b.brezillon@overkiz.com> > > NAK. > > We already have this: > > * @PIN_CONFIG_OUTPUT: this will configure the pin in output, use argument > * 1 to indicate high level, argument 0 to indicate low level. > > It also has device tree bindings: > > output-low - set the pin to output mode with low level > output-high - set the pin to output mode with high level
Bah maybe I'm misunderstanding :-(
So this is not part of the generic pin config series, but something stand-alone to augment the existing driver to do this?
So I just apply this patch right off then?
Yours, Linus Walleij
| ![\](/images/icornerr.gif) |